Why is the red light blinking on the printer?

There are four situations:

1. Your printer is not loaded with label paper. The solution is that the light will turn blue when the label paper is loaded into the printer.
   
   
2. Your printer does not identify the size of the paper.There are two manifestations.
   
   • After the printer successfully prints a label, it outputs a few blank sheets of paper and cannot print continuously, and then the printer appears red.
   • The printer only prints a small part of the text and the paper is jammed, and then the printer shows a red light.
     

     Solutions for the above two situations:

     a. Load at least than 4 consecutive sheets of paper into the printer (print side up).
     b. After the paper stop moving, press and hold FEED (red/blue light), and when you hear a beep, release the feed.
     c. The printer will learn the size of the paper at this time, and the top of the printer will light up in blue when it stops. After the process is complete, the printer is back to normal.
3. The label does not feed properly. There may be some abnormal noise at the situation.
   
   
4. It is also possible that you are using a non-original power adapter from Svantto. Please check whether your power adapter is original.